Arduino project for controlling projector at an event.
$10-30 USD
Pagato alla consegna
Arduino project for controlling projector.
Project:
I need Arduino to be programmed that can do:
1. If the light is weak (BH1750) and the time is after 20h a clock (DS1307), then send the TCP pocket over Ethernet or RS-232 to the projector to turn on. (HLK-RM04)
2. If the light is high and the time is after 6h a clock, then send the TCP pocket over Ethernet or RS-232 to the projector to turn it on. (HLK-RM04)
3. You need to make it and I need that for later to send one or two pockets to other IP addresses (leave me the possibility in comments of the program)
Why Ethernet and RS-232? Because I need to have two possibilities if the projector doesn’t have ethernet. That said I need then two programs for two scenarios. If I need an Ethernet shield, I will use one program and if I need RS-232 I will use other. I will provide you codes for power on the projector.
That output (Ethernet and Rs-232) is the only thing that different.
It would be great if you can make that clock and lux are displayed on the LCD module, just for debugging or to have some kind of clue if it’s working.
From equipment I have
- Arduino UNO
- BH1750
- DS1307
- HLK-RM04
- 5110 LCD module
- breadboard and wire
I have some knowledge about Arduino, but I can’t program that. I can connect wires as you instruct me. That can be done over TeamViewer on my computer, all code will be on that computer left.
Thanks,
Rif. progetto: #31439424
Info sul progetto
Assegnato a:
I am an Electrical and Electronics Designs Engineer specializing and Accomplished in the area of Embedded Systems, Product Design & Prototyping, Schematics, and PCB layout. I will do basic to Advanced Circuit design u Altro
11 freelance hanno fatto un'offerta media di $47 per questo lavoro
Have real-time working experience in Arduino NANO/UNO/MEGA and Raspberry PI to build a digital device to read sensor data and send it to the webserver, motor control, control relay switches and LEDs. More than 5(five) Altro
Hi there I can do this is easily I have integrated the light sensor for many automation projects We can do serial over wifi This will save you a lot of integration time and cabling headache please message me to di Altro
Hi , I am an expert , I can do this job so perfectly , just let me do it . CONTACT ME PLEASE ! 100% satisfaction guarantee 100% satisfaction priority
Hi I am embedded system engineer with 8 years of experience. i understand all your requirement. as long as you already have the code for projector we can finish this quickly
I am an electronic engineer (Master degree) with good experience in power electronic design. I have a good experience in hardware design and embedded systems (STM32 and Arduino platforms). Good experience in routing PC Altro
I am an Electrical and Electronics Engineer. I have strong knowledge and ability in preparing Electrical Engineering reports, articles, and projects. I have a good thoughtful of different experimental projects in the f Altro
I can do that compitently and insruct you on how you will complete it witout any complecation. Entrust me with the task and i will not disappoint you.
I m working on arduino from last two years I will be perfect person for this work... Please contact in case you want to collaborate.. Thank you
Arduino project for controlling projector : Can you change 5110 LCD module to OLED 0.96 inch ? do you need the button to enter parameters ?
