Grove - Rotary Angle Sensor

The rotary angle sensor produces analog output between 0 and Vcc (5V DC with Seeeduino) on its D1 connector. The D2 connector is not used. The angular range is 300 degrees with a linear change in value. The resistance value is 10k ohms, perfect for Arduino use. This may also be known as a “potentiometer ”.

For all Grove users (especially beginners), we provide you guidance PDF documents. Please download and read through Preface - Getting Started and Introduction to Grove before your use of the product.

Ready to use with microcontrollers as analog input. This product also has a compact modular design Plug-and-play grove compatible interface.

Based on picture above, the grove shield for Arduino is stacked with Seeduino V4.2. Of course you can use that shield with Arduino too :)

You can get grove hat for Raspberry Pi here. It may not be the same as product above but still can use with Raspberry Pi.

Note: Controllers are sold separately.

• Grove Interface
• Easy to Use
• Grove Base Module
• Operating Voltage: 5.0V
• Rotary Angle : 0~300 Deg
• Dimensions (mm): 19 (L) x 19 (W) x 30.1(H)

• 1 x Grove - Rotary Angle Sensor
• 1 x Grove 4 Pin Buckled 20cm Cable

• Grove-Rotary Angle Sensor v1.2 Schematic File
• Grove - Rotary Angle Sensor(P) v1.1 Schematic File
• Github repository for Rotary Angle Sensor
• CDC File

Getting Started:

• Grove - Introduction to Grove
• Grove - Rotary Angle Sensor connection and code with Arduino and Raspberry pi by wiki.seeedstudio
• Grove- Rotary Angle Sensor tutorial Seeeduino Shield