Vintage B3 Wah effect in Logic Pro for Mac

The name wah wah comes from the sound it produces. It has been a popular effect with electric guitarists since the days of Jimi Hendrix. The pedal controls the cutoff frequency of a bandpass, lowpass, or—less commonly—highpass filter. The wah pedal is also used extensively with the Hammond organ.

For the most dynamic and musical performance of the Wah effect, consider attaching an expression pedal to your MIDI master keyboard. Your master keyboard should transmit MIDI control change #11, which would normally be used to control Vintage B3 volume while playing.

Vintage B3 Wah parameters

Wah On/Off switch: Turn on or bypass the Wah effect.
Sweep MIDI Ctrl pop-up menu: Assign a MIDI controller to the Wah effect.
Type pop-up menu: Choose one of several Wah effect types.
- Classic Wah: This setting mimics the sound of a popular wah pedal with a slight peak characteristic.
- Retro Wah: This setting mimics the sound of a popular vintage wah pedal.
- Modern Wah: This setting mimics the sound of a distortion wah pedal with a constant Q(uality) Factor setting. The Q determines the resonant characteristics. Low Q values affect a wider frequency range, resulting in softer resonances. High Q values affect a narrower frequency range, resulting in more pronounced emphasis.
- Opto Wah 1: This setting mimics the sound of a distortion wah pedal with a constant Q(uality) Factor setting.
- Opto Wah 2: This setting mimics the sound of a distortion wah pedal with a constant Q(uality) Factor setting.
- Resonant LP: In this mode, the Wah works as a resonance-capable lowpass filter. At the minimum pedal position, only low frequencies can pass.
- Resonant HP: In this mode, the Wah works as a resonance-capable highpass filter. At the maximum pedal position, only high frequencies can pass.
- Peak: In this mode, the Wah works as a peak (bell) filter. Frequencies close to the cutoff frequency are emphasized.
Range knob and field: Determine the sensitivity of the Wah effect to incoming MIDI controller data.
Bite knob and field: Boost the levels of signals surrounding the cutoff frequency. Bite is effectively a filter resonance parameter, where high values make the Wah effect sound more aggressive.

Use an expression pedal to control the Wah effect

In Logic Pro, click Options in the control bar, then set the Expression knob to a value of 0.
Click Effects in the control bar, then choose controller 11 from the Sweep MIDI Control pop-up menu.
This enables control of Wah cutoff frequency with the expression pedal and requires no further setup of your master keyboard. If step 1 is overlooked, the expression pedal is used to control both Vintage B3 main volume and the Wah effect.
Note: Consult the user manual for your keyboard to learn more about use of an expression pedal.
Adjust the Range knob to set the sensitivity of the Wah to incoming expression pedal controller data.

Learn a MIDI controller to control the Wah effect

In Logic Pro, click Effects in the control bar.
Choose Learn from the Sweep MIDI Ctrl pop-up menu.
When Learn is active, the parameter is assigned to the first appropriate incoming MIDI data message.
Move the MIDI controller on your MIDI device.
Learn mode has a 20-second time-out facility: if Vintage B3 does not receive a MIDI message within 20 seconds, the parameter reverts to its original MIDI controller assignment.

Download the guides:

Logic Pro User Guide: PDF

Logic Pro Instruments: PDF

Logic Pro Effects: PDF

Helpful?

Logic Pro User Guide for Mac

Vintage B3 Wah effect in Logic Pro for Mac

Vintage B3 Wah parameters

Use an expression pedal to control the Wah effect

Learn a MIDI controller to control the Wah effect