iPhone 15 Taptic Engine
Before You Begin
Remove the following parts before you begin:
Tools
6.1-inch repair tray
ESD-safe tweezers
JCIS bit
Nylon probe (black stick)
Torque driver (teal, 0.75 kgf cm)
Removal
Use a torque driver and the JCIS bit to remove the two crosshead screws from the Taptic Engine connector cowling and one crosshead screw from the Taptic Engine. Set aside the screws. Remove the Taptic Engine connector cowling and save it for reassembly.
Caution: Don’t damage the grounding spring on the cowling.
Lift the end of the Taptic Engine flex cable off the connector. Remove the Taptic Engine from the enclosure.
Reassembly
Position the Taptic Engine in the enclosure.
Press the end of the Taptic Engine flex cable to the connector.
Position the Taptic Engine connector cowling over the end of the flex cable.
Use the teal torque driver and the JCIS bit to install one new crosshead screw (923-10031) into the Taptic Engine.
Use the teal torque driver and the JCIS bit to install two new crosshead screws (923-10031) into the Taptic Engine connector cowling.
Reinstall the following part to complete reassembly: