Mac mini (M1, 2020) Speaker

Before You Begin

Remove the following parts before you begin:

Tools

  • Nylon probe (black stick)

  • Torx T6 screwdriver

Removal

  1. Use the T6 screwdriver to remove the two T6 screws (923-02801) from the speaker.

  2. Tilt the speaker to the side as shown. Then use the flat end of the black stick to lift the end of the speaker cable off the connector.

    • Important: The speaker cable is connected to the logic board under the speaker.

  3. Remove the speaker from the housing.

Reassembly

  1. Use the flat end of the black stick to press the end of the speaker cable to the connector.

  2. Align the screw holes on the speaker with the screw holes on the logic board.

  3. Use the T6 screwdriver to reinstall the two T6 screws (923-02801) into the speaker.

Reinstall the following parts to complete reassembly:

Published Date: