iPhone 12 Pro Max Camera

Before You Begin

Warning

Read Battery Safety and follow workspace and battery handling guidelines before you begin.

Remove the following part before you begin:

Tools

  • 6.7-inch repair tray

  • ESD-safe tweezers

  • Micro stix bit

  • Nitrile or lint-free gloves

  • Nylon probe (black stick)

  • Torque driver (green, 0.45 kgf cm)

Caution

  • To avoid damaging the lenses, don’t touch the TrueDepth camera assembly or nearby parts.

  • Avoid the grounding springs on the camera cowling and enclosure.

Important

If you replace this part, it is recommended to run Repair Assistant in order to finish the repair. Repair Assistant will be available on the device after you’ve completed all reassembly steps.

Removal

  1. Place the enclosure in the repair tray with the Lightning connector facing the cutout.

  2. Use a torque driver and the Micro stix bit to remove the five trilobe screws from the camera cowling in the order shown. Hold the camera cowling in place as you remove the center screw (5). Set aside the screws.

    • Caution: Avoid touching the grounding springs.

  3. Use ESD-safe tweezers to tilt up the camera cowling from the left side. Then slide the cowling tab out of the slot on the right of the enclosure. Save the cowling for reassembly.

  4. Use ESD-safe tweezers to lift the end of the top camera flex cable off the connector.

    • Note: One camera flex cable covers the other.

  5. Use ESD-safe tweezers to lift the end of the bottom camera flex cable off the connector.

  6. Gently hold the camera flex cables together and lift the cameras out of the enclosure.

Reassembly

  1. Put on the gloves to prevent contamination of the camera lenses. Then hold the replacement cameras with the lenses facedown and remove the protective cover from the camera lenses.

  2. Tilt the bottom edge of the cameras down and toward the battery as shown. Ensure that the camera flex cables fit into the channel in the enclosure.

  3. Position the cameras in the enclosure.

  4. Press the end of the bottom camera flex cable to the connector.

  5. Press the end of the top camera flex cable to the connector.

  6. Lightly press the cameras into the enclosure.

  7. The camera cowling has a tab that fits into a slot under the lip on the right side of the enclosure. Inspect the tab and grounding springs on the cowling for damage before reassembly.

  8. Hold the cowling with ESD-safe tweezers and slide the cowling tab into the slot. Then lower the cowling onto the cameras.

    • Caution

      • Avoid touching the grounding springs as you reinstall the camera cowling.

      • Ensure that the screw cutouts in the cowling align with the screw holes and that the tab is inside the slot in the enclosure. A misaligned camera cowling may affect display image quality.

  9. Hold the camera cowling in place with your finger. Use the green torque driver and Micro stix bit to install five new trilobe screws (923-05028) into the camera cowling in the order shown.

Reinstall the following part to complete reassembly:

Important

  • After you’ve completed all reassembly steps, Repair Assistant will be available on the device and is recommended to finish the repair. Learn how to initiate Repair Assistant.

  • Camera calibration requires a well-lit room and will take approximately 5 minutes to complete. Follow the onscreen instructions.

Published Date: