Skip to main page content
U.S. flag

An official website of the United States government

Dot gov

The .gov means it’s official.
Federal government websites often end in .gov or .mil. Before sharing sensitive information, make sure you’re on a federal government site.

Https

The site is secure.
The https:// ensures that you are connecting to the official website and that any information you provide is encrypted and transmitted securely.

Access keys NCBI Homepage MyNCBI Homepage Main Content Main Navigation
. 2004 Aug;151(4):151-7.
doi: 10.1049/ip-nbt:20040824.

Microthermoforming as a novel technique for manufacturing scaffolds in tissue engineering (CellChips)

S Giselbrecht  1 , T Gietzelt, E Gottwald, A E Guber, C Trautmann, R Truckenmüller, K F Weibezahn
Affiliations

Microthermoforming as a novel technique for manufacturing scaffolds in tissue engineering (CellChips)

S Giselbrecht et al. IEE Proc Nanobiotechnol. 2004 Aug.

Abstract

The CellChip is a microstructured polymer scaffold, which favours a three-dimensional cultivation of cells within an array of cubic microcontainers. The manufacturing process used so far is microinjection moulding combined with laser-based perforation. In a first attempt to simplify the process, costly perforation was avoided by using commercially available, inexpensive microfiltration membranes for the bottom of the microcavities. Microthermoforming is a promising novel technique which allows the CellChip to be produced from thin film. Working pressures of approximately 4000 kPa were required for the adequate moulding of 50 microm thick films from three different polymers (polystyrene, polycarbonate, cyclo-olefin polymer). Integrating drafts and chamfers in micromoulds is not going to eliminate an uneven thickness profile, but reduces demoulding forces. Microthermoformed CellChips of polycarbonate were perforated by an ion track technique to guarantee a sufficient supply of medium and gases to the cells. The prestructured CellChips were irradiated with 1460 MeV xenon ions at a fluence of a few 10(6) ions/cm2. The tracks were etched in an aqueous solution of 5 N NaOH at 30 degrees C, which resulted in cylindrical pores approximately 2 microm in diameter. Microinjection-moulded, membrane-bonded and thermoformed CellChips were subjected to comparative examination for viability in a cell culture experiment with parenchymal liver cells (HepG2). The cells stayed viable over a period of more than 20 days. No significant differences in viability between injection-moulded, membrane-bonded, and thermoformed CellChips were observed.

PubMed Disclaimer

Similar articles

See all similar articles

Cited by

LinkOut - more resources