3D Printed Stand
This simple stand is designed for the Adafruit FunHouse. It features a nice brick texture that is reminiscent to the Yellow Brick Road from The Wizard Of Oz.
The stand features four M3 size mounting holes for securing the Adafruit FunHouse. It is optimized to 3D print without any support material.
Prerequisite Guides
Take a moment to walk through the following guides:
Home is where the heart is...it's also where we keep all our electronic bits. So why not wire it up with sensors and actuators to turn our house into an electronic wonderland....
guides with product
$34.95
In Stock
Totaling 420 pieces, this M3 Screw Set is a must-have for your workstation. You'll have enough screws, nuts, and hex standoffs to fuel...
$16.95
In Stock
Perhaps your smart phone, tablet, or even your Raspberry Pi 4, charges off of USB, but can you really trust that charging station at the airport? Now you can control when to allow...
$4.95
In Stock
Page last edited March 08, 2024
Text editor powered by tinymce.
