Boomy Pi Airplay Boombox

by Ruiz Brothers

published November 08, 2017, last edited November 08, 2017

posted in Components 3D Printing Raspberry Pi/ Pi Zero

Save Download

Intermediate

Project guide

Install Buttons

Install Button Actuators

Insert the button actuators into the button hole cutouts. The base will keep them from falling through. Orientate the case so the button actuators stay in place.

Mount Button PCB

Place the button PCB over the two standoffs that are next to the button actuators. Line up the mounting holes with the standoffs. While holding the button PCB in place, insert and fasten 2x M2.5 x 5mm short machine screws. Fasten until fully tightened.

Test Buttons

It's a good idea to test out the button actuators by pressing them to see how they feel. They should be press in freely, independent from each other when pressed. If you used hard PLA plastic to print them, you may need to cut them up so they're separated into individual pieces.

Page last edited November 06, 2017