- Read credit on load
- Press <- left, load .bin dump from storage
- Press -> right, dump EEPROM .bin to storage /ext/app_data/coffee_eeprom
- Hold . center, Enter credit editor mode
- <- -> to move the digit cursor
- up/down to increase/decrease the digit value (min 0.01 max 655.35)
- SDA -> Pin 15
- SCL -> Pin 16
- VCC (3.3V) -> Pin 9
- GND -> Pin 18
Provide two 4k7 ohms Pull-Up resistors from SDA to VCC and one from SCL to VCC
The upper 6 pins male header is not required (unless you want to use the PicKit2 either)
I am not responsible for any illegal use of this tool. Edit the credit is like stealing.