The enclosure can be printed with any 3D printer. It can be assembled without any screws. You can put the enclosure on a desk or mount it on a wall.

I print all parts on my Prusa MK3 with PLA. I'm using a 0.20mm layer height and 20% infill. Less infill will probably work too.

HKCam Enclosure

• Body_support.stl – housing for a Raspberry Pi Zero W and camera module (with support)
• Lid.stl – lid which snap-fits onto the body
• Stand.stl – a stand which can be attached to the body at the bottom
• Wall Mount.stl – wall mount which can be used in combination with brackets of the Articulating Raspberry Pi Camera Mount

Articulating Raspberry Pi Camera Mount Parts

• Nut.stl and Bolt.stl
• ffLink_90_support.stl – female-to-female link (with support)
• mfLink_90_support.stl – 90° male-to-female link (with support)
• mfLink_support.stl – male-to-female link (with support)
• Block.stl – Block

Articulating Raspberry Pi Camera Mount for Prusa MK3 and MK2 by sneaks is licensed under the Creative Commons - Attribution license.

Enclosure Examples

	Parts
	1 Body in black 1 Lid in yellow 1 Stand in black
	1 Body in black 1 Lid in yellow 1 Wall Mount in black 3 Bolts in yellow 2 Nuts in yellow 1 mfLink_90_support in black 1 ffLink_90_support in black 1 Block in black