automate bootloader+firmware+update+self_test on bus pirate v3 with arduino and python. Firmware 7.1 bootloader 4.5
WARNING CHANGE BOOTLOADER CAN BRICK YOUR BUS PIRATE, YOU SHOULD NOT USE THIS PROJECT xD
VIDEO DEMO:
https://www.youtube.com/watch?v=cnYpEc1Y6F0
NEVER USE USB-HUBS, CONNECT ALL DIRECTLY TO PC
- buy a usb diy male cable + female usb diy cable
- connect all cables together except VCC (red)
- buy two 5v relay
- connect VCC from both usb to relay
- connect pin 12 from arduino to control this relay
- connect +5v + gdn from arduino to relay
- Connect PGD + PGC to another relay
- connect pin 11 from arduino to control this relay
- with a jumper or two female dupont cables connect:
- +5v with VPU
- +3v3 with ADC
something like this chaos:
- connect arduino to PC via usb cable
- connect bus pirate to PC via frankestein diy-cables
- flash arduinofirm/arduinofirm.ino to your arduino
- install python3 + pip install pyserial
- edit autobuspirateupgrade.py and put your COM for arduino and for bus pirate
- run: python autobuspirateupgrade.py
Done!
