piler-smtp listening on IPv6 address? #94
-
|
Hello, That would be very interesting, since there are significantly more IPv6 addresses available than IPv4 addresses. Best regards |
Beta Was this translation helpful? Give feedback.
Replies: 2 comments 2 replies
-
|
I think it supports ipv6 already. Can you verify? |
Beta Was this translation helpful? Give feedback.
-
|
As I showed with lsof, piler-smpt only listens on type IPv4. You can't telnet to the IPv6 address and port 25 either. It rejects that. I'm asking because it could be that IPv6 can be supported, but only needs to be enabled. But I don't know Piler well enough for that yet, I'm just working my way into it. |
Beta Was this translation helpful? Give feedback.
-
|
The listen address is 0.0.0.0 by default, which is an IPv4 address. Try setting ::1 or your actual ipv6 address to listen_addr parameter. It works, I've tested it. |
Beta Was this translation helpful? Give feedback.
-
|
Thank you very much! That was it. But it only works with either IPv6 or IPv4, but it works and that's the most important thing at the moment. |
Beta Was this translation helpful? Give feedback.
The listen address is 0.0.0.0 by default, which is an IPv4 address. Try setting ::1 or your actual ipv6 address to listen_addr parameter. It works, I've tested it.