Skip to content

Files

Failed to load latest commit information.

Latest commit

 Cannot retrieve latest commit at this time.

History

History
 
 

macropad

Folders and files

NameName
Last commit message
Last commit date

parent directory

..
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Adafruit MacroPad RP2040

AdafruitMacropad

A RP2040-powered Macropad with a 3x4 layout.

Make example for this board (after setting up your build environment):

qmk compile -kb adafruit/macropad -km default

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Features

  • Raspberry Pi RP2040 Chip + 8MB Flash memory - Dual-core Cortex M0+ at ~130MHz with 264KB of RAM.
  • 3x4 Mechanical key switch sockets - accepts any Cherry MX-compatible switches. Individually tied to GPIO pins (not matrix wired)
  • One NeoPixel RGB LED per switch, on north side.
  • Rotary encoder, 20 detents per rotation, with push-switch on GPIO pin. Push switch is also used for entering bootloader mode when held down on power-up or reset.
  • 128x64 SH1106 Monochrome OLED display - On high-speed hardware SPI port for quick updates.
  • 8mm Speaker/Buzzer - With Class D amplifier and RC filter, can be used to make simple beeps and sounds effects. (Unsupported for now)
  • STEMMA QT Connector - Allows adding any I2C sensors/displays/devices with plug-and-play cables.
  • Reset button - On the side, for quick restarting, press it twice to enter bootloader.
  • Four M3 mounting bosses - Make custom enclosures easily.

Bootloader

Enter the bootloader in 4 ways:

  • Bootmagic reset: Hold down the key just below the rotary encoder push-button on power-up.
  • Physical reset button: Press twice the button on the side while the board is connected.
  • BOOT button Hold down the rotary encoder push-button on power-up or reset.
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available.