REALITi 17+

Multiple Screens
- Improved logs window performance when lots of logs.
- Enabled unit measurements' conversion in IBP and NIBP of the following monitors: Zoll R, Philips MRx, Schiller Defigard Touch7, Generic Monitor, Generic Defib, Generic Wave, Generic Numerics, GE Carescape B850, Philips IntelliVue MX800 and WelchAllyn Connex.
- Monitors that do not support the conversion to unit cmH2O will remain as mmHG.
- Resolved issue in Schiller Defigard Touch7 where NIBP value gets changed by the conversion toggle button in CO2 in Unit Measurements
- Enabled Pacer Settings' Default Output and Rate for Zoll Propaq MD, Zoll X, Schiller Defigard Touch 7 and Tempus LS.
- Enabled Pacer Settings' Remember Last Output and Rate for Zoll Propaq MD, Zoll R, Zoll X, Schiller Defigard Touch 7 and Tempus LS.
- Fixed ECG waveform not being changed if the new waveform was the same as the previously loaded scenario.
Capnostream 35
- Resolved crash issue on starting Capnostream 35.
Corpuls 3/3T
- Fixed issue with metronome count not reverting to original configured ratio.
- Fixed issue with Start Analysis being played just after powering on, no delay.
- Fixed issue with metronome not resetting to Adult 30:2 when C3/C3T is powered off.
Hamilton T1
- Changed F Total b/min from decimal to integer in Alarms.
- Changed F Total b/min from decimal to integer in the Monitoring section.
Lifepak 15
- Resolved issues on NIBP countdown timer and MAP display overlap.
- Enabled reset on contrast when the monitor is turned off.
- Resolved issues with the Home and high-contrast Sunvue buttons, where the lower portion was unresponsive to clicks.
- Resolved crash issue when changing back from high contrast Sunvue display to color display.
- Resolved issue on metronome.
- Enabled correct state for CPR button when switching from AED to manual defibrillator.
Revel Vent
- Resolved issue on audible tone looping after swiping from left to exit the ventilator.
Schiller Defigard Touch 7
- Enabled flashing alarm light and parameter field flashes in the secondary Pulse field when limits are - exceeded.
- Enabled alarm light flash for HR.
- Added heart icon in the second Pulse parameter field
- Fixed primary Pulse background to blue when changing from HR to Pulse.
- Resolved issue on secondary Pulse not changing to dashes when Control’s finger probe is off.
- Resolved issue on HR, SpO2 and Pulse not flashing in both alarm light and parameter fields when limits are - exceeded.
- Fixed issue on primary Pulse not changing back to HR field when the source is AUTO and becomes unhidden.
Zoll R
- Resolved issue on “NIBP MEAS ABORTED” message appearing when NIBP value in Control Parameter Settings is changed.