[gammu]
device = com1:
connection = at9600

[smsd]
service = sql
sql = mysql
driver = odbc
host = gammu
user = gammu
password = supersecretpassword
database = gammu
logfile = C:\gammu\smsdlog
debuglevel = 0
runonreceive = C:\scripts\gammu\runonreceive\RunOnReceive.bat


###   SEQUENCE OF OPERATION   ###

#Whether to check if phone wants to enter PIN. Default is 1 (enabled).
CheckSecurity = 0

#The number of seconds between testing for received SMSes, when the phone is busy sending SMSes. Normally a test for received SMSes is done every CommTimeout seconds and after each sent SMS. Default is 15.
ReceiveFrequency = 1

#The number of seconds between performing a preventive soft reset in order to minimize the cases of hanging phones e.g. Nokia 5110 will sometimes freeze to a state when only after unmounting the battery the phone will be functional again. Default is 0 (not used).
ResetFrequency = 0

#How many seconds should SMSD wait after there is no message in outbox before scanning it again. Default is 30.
CommTimeout = 1

#The number of seconds between refreshing phone status (battery, signal) stored in shared memory and possibly in service backends. Use 0 to disable. You might want to increase this for higher throughput. Default is 60.
StatusFrequency = 60

#Shows how many seconds SMSD should wait for network answer during sending sms. If nothing happen during this time, sms will be resent. Default is 30.
SendTimeout = 30

#The number of seconds how long will SMSD sleep before checking for some activity. Please note that setting this to higher value than 1 will have effects to other time based configurations, because they will be effectively rounded to multiply of this value. Setting this to 0 disables sleeping. Please note this might cause Gammu to consume quite a lot of CPU power as it will effectively do busy loop. This sleep is utilized only if the main loop (sending and receiving messages) takes less than defined time. For example if you set LoopSleep to 5 seconds and sending messages take 10 seconds, no sleep will be done in the iteration which is sending messages. Also the sleep time is lowered by the already processed time. Default is 1.
LoopSleep = 1


###   SETTINGS   ###

#How many times will SMSD try to resend message if sending fails. This is tracked per message and currently supported only with SQL backends. Default is 1.
MaxRetries = 2

#How long to wait before resending failed message (needs to be enabled by MaxRetries). Is used in update_retries. Default is 600.
RetryTimeout = 600

#The number of seconds how long will SMSD wait for all parts of multipart message. If all parts won’t arrive in time, parts will be processed as separate messages. Default is 600 (10 minutes).
MultipartTimeout = 600

#New in version 1.34.0. Whether to automatically hangup any incoming calls. Default is 0 (disabled).
HangupCalls = 1

# Whether to check phone battery state periodically. Default is 1 (enabled).
CheckBattery = 0

# Whether to check signal level periodically. Default is 1 (enabled).
CheckSignal = 1

#New in version 1.37.90. Whether to check network status periodically. If phone is reported to be not on the network, SMSD tries to power it on. Default is 1 (enabled).
CheckNetwork = 1